Mounting system for pitched roofs, flat roofs and fronts

The development of the new mounting system TRI-STAND is based on well-founded know-how and years of practical experience. The knowledge gained from the implementation of numerous solar systems resulted in a mounting system that is ideally suited for all applications – from small stand-alone systems to large grid-connected systems, on pitched and flat roofs as well as fronts.


Insertion profile TS – The aluminium profile
The insertion profile TS of the TRI-STAND mounting system allows the easy, quick and thus efficient installation of all popular framed solar modules. After the insertion of the modules into the aluminium profile, the modules are held in place by their own weight and friction. The photovoltaic modules do not need to be screwed in.

Universal profiles UP / UP-L / UP-S – The base profiles
The universal profiles UP, UP-L and UP-S are the basic profiles of the TRI-STAND mounting system. The universal profile UP is used for standard systems. For applications with low static stresses the universal profile UP-L is used, however for great static stresses UP-S. The revolutionary design of the universal profiles allows for two types of installation: the easy to install insertion system with cross bracing and the insertion profile TS or the cost-effective clip system with middle and end clips. – The choice is yours.


SafeClick SC – The secure connector
SafeClicks connect the universal profiles of the TRI-STAND mounting system securely and easily with its insertion profiles. The practical design of the SafeClick allows easy installation by simply clicking in the insertion profiles. Drilling is not necessary.

Middle rail TS-M – The optimal reinforcement
In the case of vertical module insertion and acceptance of pressures of more than 2400 N/m², some module manufacturers specify the use of a middle support. The TRI-STAND middle rail TS-M is specifically designed for the mounting system and the ideal support for all popular modules.

TRI-STAND mounting accessories

Roof hooks
For the assembly of substructures first fastenings must be installed at the appropriate grid spacings. On tiled roofs, the roof hooks are attached either directly to the rafter or to distance battens above the rafter. Roof hooks are available for almost any type of tile and are secured by means of seating bolts.

Roof fold clamps
In the case of plate fold roofs, the clamps are installed directly at the fold. The clamps consist of two stainless steel metal sheets, which are bolted together. The roof fold clamps are available in a round version, especially for Kalzip roofs. The substructure can be mounted on the clamps, without disturbing the roof surface.

Hanger bolts
For the installation on a corrugated roof type, the existing screws are replaced by hanger bolts. This secures the corrugated roof, and at the same time the hanger bolts can be used for the installation of the substructure. This provides the base for the installation with a minimum of time and effort.

Renosol plates
For flat roofs, generally Renosol plates are used. The gravel is removed from the required flat roof area, a protective mat or fleece is laid and the Renosol plate is placed on this. Then the TRI-STAND profiles UP and UP-S can be riveted directly to the Renosol plate. Finally, the Renosol plates must be weighed down again with gravel, in order to meet the static requirements.